RBI:Guidelines on Note Authentication and Fitness Sorting Parameters

 
Source::RBI::May 13,2010

RBI on on Tuesday 11th May 2010 issued Guidelines on Note Authentication and Fitness Sorting Parameters, highlights of the guidelines are as follows:

Date:  May 11, 2010
Installation of Note Sorting Machines – Note Authentication and Fitness Sorting Parameters

RBI/2009-10/459
DCM(R&D)No.G-26/18.00.14/2009-10

May 11, 2010

The Chairman & Managing Director /
Chief Executive Officer
All Scheduled Commercial Banks
(including RRBs)
Scheduled State Co-operative Banks /
Scheduled (Primary) Urban Co-op Banks

Dear Sir/Madam

Installation of Note Sorting Machines –
Note Authentication and Fitness Sorting Parameters

Please refer to paragraph 5 of our circular DCM. No. Cir. NPD. 3161/09.39.00 (Policy)/ 2009-10 dated November 19, 2009 on the captioned subject enclosing therewith our Directive DCM. No. Dir. NPD/3158/2009-10 of date.

2. We had, vide the above circular, mentioned that machines installed by banks for processing banknotes should conform to the standards / parameters prescribed by Reserve Bank of India from time to time. Accordingly, the draft guidelines on ''Note Authentication and Fitness Sorting Parameters'' were placed on our website on December 23, 2009 seeking comments / views.  After taking into account the comments received from various stakeholders including banks, equipment manufacturers and members of public, the guidelines on ''Note Authentication and Fitness Sorting Parameters'' have been finalized, which are enclosed herewith.

3. The guidelines may be implemented with immediate effect.

4. Please acknowledge receipt.

Yours faithfully

(S.K. Maheshwari)
General Manager

Encl : 3
 Guidelines on Note Authentication and Fitness Sorting Parameters

1. Introduction

A fit note is a note that is genuine, sufficiently clean to allow its denomination to be readily ascertained and thus suitable for recycling. An unfit note is a note that is not suitable for recycling because of its physical condition or belongs to a series that has been phased out by Reserve Bank of India. All the fitness parameters laid down in this document are to be evaluated individually. A note must pass all the fitness parameters to be considered fit for recycling. 

These parameters provide the minimum standards for cash handling machines used by banks (hereinafter called ‘the machines’). Notes can only be recycled / reissued if they are evaluated as genuine and fit according to these parameters. Authenticity check is a prerequisite for fitness sorting. Fitness sorting can be done only in case of genuine notes. The machines shall be able to identify and separate suspected counterfeits and notes which are unfit for circulation in terms of these standards in a reliable and consistent fashion. 

The Reserve Bank of India phases out certain series (issue) of notes from circulation from time to time. These notes, though considered legal tender unless otherwise specified, are unfit for recycling. As and when the Reserve Bank of India decides to phase out a specific series (issue) of a specific denomination of notes, the machines shall sort all the phased out notes as unfit, irrespective of their physical condition.

2. Applicability

These parameters are applicable to machines operated by banks, either directly by their staff or indirectly by their agents. These machines can be of any of the following:

1. machines which check the authenticity and fitness of notes, i.e. note processing machines / note sorting machines, and
   
2. machines which check only the authenticity of notes, i.e. note authentication machines. All these machines shall classify the individual notes as either genuine or suspect.
   

3. Authenticity Check

The machines shall perform authenticity check with reference to the features of genuine notes as disclosed by the Reserve Bank of India from time to time. Any note which is not found to be having all the features of a genuine note shall be classified by the machine as suspect.

4. Fitness Sorting
 
As a part of fitness sorting, notes with any visual or physical defects are to be sorted as unfit as per the criteria set out in Table 1.

Table 1: Sorting Criteria
Sl. No.	Feature	Criteria
1	Soiling	General distribution of dirt across the entire note
2	Limpness	Structural deterioration resulting in a marked lack of stiffness
3	Dog-ears	Corner folds
4	Tears	Lengthwise and crosswise cuts
5	Holes	Holes of a specific diameter
6	Stains	Localised concentration of dirt
7	Graffiti	Deliberate graphic alteration of the note
8	Crumples	Multiple random folds
9	Decolouration	Lack of ink on part or whole of the note, e.g. a washed note
10	Folds	Folds reducing the length or width of the note
11	Repair	Note repaired using adhesive tape/ paper/ glue

(i) Soiling Soiling refers to the general distribution of dirt across the entire note or in some patterns. It is a measure of the loss of reflectivity from the unprinted areas due to dirt, ageing (yellowing), wear and extraneous markings and includes decolouration due to ageing, excessive folding wear and other wearing. Soiling increases the optical density and decreases the reflectance of the notes. Notes exceeding the soiling levels set out in Table 2 shall be sorted as unfit. Both the obverse and the reverse of the note shall be checked for soiling. Table 2: Soiling Levels Sl. No. Denomination Maximum Density difference Minimum Reflectance Filters 1 Rs. 5 0.07 85 % Yellow 2 Rs. 10 0.07 85 % Yellow 3 Rs. 20 0.06 87 % Yellow 4 Rs. 50 0.06 87 % Yellow 5 Rs. 100 0.05 90 % Cyan 6 Rs. 500 0.04 93 % Cyan 7 Rs. 1000 0.03 95 % Cyan (ii) Limpness Limpness relates to structural deterioration or wear resulting in a marked lack of stiffness in the note paper. Notes with a very low stiffness shall be sorted as unfit. Notes with very low stiffness of paper, i.e. with paper which is worn out in circulation or mechanically mutilated shall be sorted out as unfit. Detectors for paper quality shall be adapted to the same level as for soiling. (iii) Dog-Ears Notes with dog-ears with an area of more than 130 mm² and a minimum length of the smaller edge greater than 10 mm shall be sorted as unfit. Chipped notes shall also be sorted as unfit. (iv) Tears Notes exhibiting at least one tear at the edge shall be classified as those having tears. Notes with tears larger than those indicated in Table 3 shall be sorted as unfit. Table 3: Tears Sl. No. Direction Width Length 1 Vertical 4 mm 8 mm 2 Horizontal 4 mm 15 mm 3 Diagonal * 4 mm 18 mm * Measured by drawing a straight line from the peak of the tear to the edge of the note where the tear begins (rectangular projection), rather than measuring the length of the tear itself. (v) Holes This refers to notes with at least one visible hole. Notes with holes with area exceeding 10 mm² shall be sorted as unfit. (vi) Stains Stains are visible markings which are not part of the feature of a note. Notes shall be detected as unfit if localized - i.e. with limited extension – stain can be recognised on its surface. In case the total area covered by stains exceeds 500 mm², the note shall be sorted as unfit. A note with a single stain covering an area of more than 200 mm² shall be sorted as unfit. Both the obverse and the reverse of the note shall be checked for stains. (vii) Graffiti Graffiti refers to deliberate graphic alteration of the note with for example, figures or letters. Fitness sorting criteria in case of graffiti shall be the same as those for stains. Both the obverse and the reverse of the note shall be checked for graffiti. (viii) Crumples/ Folds Crumpled / folded notes shall be sorted as unfit if the folds result in reduction of the original note in length or width greater than 5 mm. (ix) Decolouration Notes affected by decolouration shall be sorted as unfit if the ink is partially or wholly missing from its surface. Both the obverse and the reverse of the note shall be checked for decolouration. (x) Repair A repaired note is created by joining parts of the same note together, for example, by using extraneous matter such as tape, paper or glue. Notes with the following types of repairs shall be sorted as unfit: Repairs covering an area greater than 100 mm²; or Thickness of the extraneous matter 50 μm or more; or Width of the extraneous matter 10 mm or more; or Length of the extraneous matter 10 mm or more. 5. Mutilated, Imperfect and Mismatched Notes A mutilated note is note, of which a portion is missing or which is composed of more than two pieces. An imperfect note is a note, which is wholly or partially, obliterated, shrunk, washed, altered or indecipherable but does not include a mutilated note. A mismatched note is a note, which has been formed by joining a half note of any one note to a half note of another note. Such notes shall be classified as unfit.